This device is useful and cost-effective

To make it easier to build picture frames, Club member Donald Peters of Pryor, Oklahoma, built this sliding stock support for less than $4. For the slide rails, he attached two lengths of conduit between his miter saw and a 2x10 scrap. He fashioned the sliding table out of two 12-in. squares of plywood, two 12-in.-long hardwood scraps and four short lengths of PVC pipe cut in half to serve as slides. To lock the support table in place, he welded a nut and inserted an eye bolt onto another small length of pipe thatís fitted over one of the slide rails. Brought to you by: American Profile